Dd-wrt Wireless Router Bridge Linksys 160n And Wrt54gs

On this find out how to guide I will be showing you the way create a wireless bridge between a Linksys 160n wireless router and a Linksys WRT54GS wi-fi router that has been modded with the DD-WRT firmware. You would possibly ask your self what is a wi-fi bridge.You also could ask your self why you would need to create a wireless bridge in the first place. Nicely a wi-fi bridge is if you connect one router to another router without utilizing any laborious wired cables. You may wish to create a wi-fi bridge for a few of the following reasons.

Laptop are positioned at totally different ends of your house and you can't run a ethernet cable between the two router. You need to hyperlink to you neighbors network so you may share web service, information, and media corresponding to music and movies. The chances are limitless with regards to networking routers collectively utilizing wireless.

For the wireless bridge setup I might be utilizing the next ip handle and subnet setup:

* Wi-fi Router 1 = Linksys WRT160n 192.168.1.0/24
* Wireless Router 2 = Linksys WRT54GS-WRT mod 10.0.1.0/24

The Linksys WRT 160n wireless router can be straight connected to the Web service, and the Linksys WRT54GS DD-WRT modded router will create the wireless hyperlink between the 2 routers. One of the simplest ways to setup your wi-fi bridge is to have a laptop that has both a wifi connection and a ethernet connection. To start the installation, use your wi-fi connection to connect to router 1, which is the Linksys WRT160N. After you have got linked the router, open your net browser and kind in the default gateway which should be 192.168.1.1. Click on on the Status Tab and ensure that router 1 has a internet connection.

After you realize that the first router has a web connection, go to the Wi-fi Safety Tab and setup the encryption type and paraphrase key. Just be sure you are utilizing compatible encryption between both of the routers.linksys-wrt160n-wpa-wi-fi-security

After you've gotten set the encryption kind and key on the first router, disconnect from this router. Now hook up with the WRT54GS DD-WRT modded router, then go to the setup tab and alter the native network to 10.0.1.0 or no matter network vary you prefer.

* Local Ip Address: 10.0.1.1
* Subnet Mask: 255.255.255.0
* Gateway: 10.0.1.1
* Local Dns: 10.0.1.1

After you've modified the network setup on your modded DD-WRT router, disconnect from the router then reconnect to so that you just receive your new ip address. Your new ip tackle should be somewhere throughout the 10.0.1.zero network. Now open an online browser at point it towards 10.0.1.1, which is now the default gateway in your WRT54GS DD-WRT modded router.

Now go to the standing tab and click on the wireless tab. Within the wireless tab you must see a button that says website survey. The site survey button is positioned in direction of the underside of the page. All you have to do now could be select router 1 from the listing, which ought to be the Linksys WRT160N.

After you've chosen router 1 from the listing, go to the wi-fi tab and click on on the wi-fi security tab. All it's a must to do now could be input the exact same encryption sort and key that you setup for router 1. After you have set the encryption kind and key into ybur modded DD-WRT router, all you need to do is apply the settings. You must now have a wi-fi hyperlink between the Linksys WRT160N and the Linksys WRT54GS. Now join utilizing a wireless connection to the DD-WRT modded router, and make sure your web connection work.

By: gregwil0os

Article Directory: http://www.articledashboard.com

DD-WRT Wireless Router Bridge