Hydraulic Cylinder Seals Failure: The Main Causes

One of the main cause of failure in hydraulic cylinders is seal failure. Though the cost of a hydraulic cylinder seal is not very high, it can become very exensive for loss of production and downtime failure when the seal becomes the cause of cylinder failure. If there is a problem in the cylinder, it is better to concentrate on the problems or reasons that are causing the problem of seal failure. The main causes of hydraulic seal failure are as follows:

When the seal is not installed properly: It is very important to consider the following points when the seal is installed:
lCleanliness
lSeal protection from cuts and nicks
lPerfect lubrication
lOver tightening of the seal gland. This happens when during insatllation there is a folding over a seal lip.
lJust check whether the seal is placed upside down. This is a common problem.
The precaution here is to be very careful while installing the hydraulic seal.

When the hydraulic system is contaminated: This is another main cause of hydraulic seal failure. The contamination is caused by external elements like mud, grit, dust, dirt, ice etc. There can be contamination from internal problems as well like metal chips circulation, fluid, hoses and other degradable system's products break-down. Most hydraulioc systems are externally contaminated due to rod retraction. That is why proper installation of a rod wiper or scraper is a good solution. The prevention of internal contamination can be done by proper filtering of fluid system. You know that seal is contaminated when you see scored cylinder and rod bore surfaces, too much of seal wear and leakage etc.

Incorrect material selection: When there is chemical breakdown of the material of the seal, it is due to incorrect material selection. Another cause may be due to change of hydraulic system fluid. Application of non-compatible materials is one the main cause failure of seal elements. It can lead to seal lip loss interface, seal durometer softening, too much of shrinkage or swelling. When your hydralic seals become discolored, that is also a pointer of chemical attack.

Heat degradation: When you see your hydraulic seal exhibiting a hard, brittle look or when you see parts of the seal lip or body breaking way, it means that there is heat degradation. Heat degradation occurs due to loss of sealing lip effectiveness. The main causes for this are incorrect seal material, very high friction, very high lip loading, and very close to outside heat source. In order to solve the problem of heat degradation, it is necessary to reduce seal lip interference, to change the material of seal or to increase lubrication.

Conclusion: To solve the problem of hydraulic cylinder seal failure, it is not necessary that you buy replacement seals from manufacturers of hydraulic cylinder. Instead, it is your hydraulic seals manufacturers, who can provide you with exact sized seals. If the problen keeps on occuring, consult you supplier to find a solutin that can increase the life of your hydraulic seal.
For more information on hydraulic Machines, check out Hydraulic Equipment Manufacxturers.

By: rupunkel

Article Directory: http://www.articledashboard.com

A professional search engine marketer and writer with 6 years of industry experience. Presently working as a Senior Content Manager, developing and managing content for websites and portals, in one of the leading B2B marketplace and web solution provider company based in India.