Learn How To Fix Red Ring Of Death Today

To begin the repair process, take the Xbox 360 case apart. Use a fine-tipped poker to punch through the small gray, rectangular holes to remove the faceplate. After you've done that, move the latch up to the DVD drive so that can also be removed. You will find a metal screw below the plastic case, and that will need to be screwed off.

After that, you must safely remove the motherboard if you're going to know how to fix red ring of death. Disconnect all of the cables that connect to the motherboard and the other small parts of the machine. Then you should be able to take the DVD drive, motherboard, and cooling fan out of the Xbox 360 casing.

Carefully carry out this step

After that, turn the mother onto the other side and use a poker to remove the X-clamp that is attached below the heat sink. Then, you can unscrew the heat sink to get access to the graphics processing unit and the central processing unit.
You have to do this while you are following the other steps in the Xbox 360 manual, or you will damage your machine even more.

The CPU and GPU must both be removed so that the machine can be properly cleaned. If you clean these units properly, then the Xbox 360 will no longer freeze. This is probably the most important step in learning how to fix red ring of death, so approach it very cautiously.

Use of arctic silver thermal compound

The repair of the red ring of death is the next application of arctic silver. You have to apply arctic silver thermal compound gently over the GPU. This arctic silver thermal compound is available at any computer hardware shop at a cheaper rate.

This arctic silver thermal compound can be fixed in the Xbox 360 for about fifteen to twenty minutes. Then two nylon washers can set on each of the screws appear on the heat sink. These screws then have to be replaced in the motherboard. Then two more nylon washers have to be added to the screws later.

Now you know how to fix red ring of death

The red ring of death can be fixed by placing the heat sink on the peak of screws and then pushing it slightly down which is to be done as the next step.

The Xbox 360 is switched on and can be played continiously once everything is back together and fitted properly. Now you have to answer for the question of how to fix red ring of death

By: Steve Jackson1982

Article Directory: http://www.articledashboard.com

Click here to Download Free Special Report on how to Fix Your Xbox